GModz Tuts
Se7ensins Un-Official Lobby Verifier
OK, So i finally got the Demon working (redid a few Quick solder points in case, Re wired the CR completely, Got a new CR thanks to
The Coon
) And realized when I updated my DemoN, Jrunner crashed and I forgot so it was still on 1.0. so I updated to 1.4, Got it to Attempt to glitch with the DemoN Nand enabled (before it wouldnt even turn on) and It will NOT boot Xell. I have been sitting here for about 10 minutes trying. I tried open Jumper, Closed Jumper, Cap open, Cap closed. What more can I do? I used the 50 ohm Low Loss shielded cable and grounded it. Any Ideas? I have NEVER had a console be so stubborn in my life. The console I built for
The Coon
glitches first cycle right away, then again, His is rgh1
Sooo, Any Ideas? Im about to sell it off.. Getting sick of messing with it. I literally started building it april 2012.
Sooo, Any Ideas? Im about to sell it off.. Getting sick of messing with it. I literally started building it april 2012.