What's new

Question RGHing an Xbox 360 from scratch

JoshuaFerns

JoshuaFerns

Newbie
Messages
2
Reaction score
0
Points
10
Sin$
0
Hi, I'm looking forward towards modding my old Xbox 360 console which, after doing some research, found out that its a 4gb corona with the latest 17559 dashboard on it. I'm actually a total noob at this however, since my console is kinda old and with the conception that nothing too big is gonna happen with the 360s in the near future I think its a good time to do some modding and if I could get some help in doing so, it would be much appreciated. Thanks.
 
gunn1e

gunn1e

Enthusiast
Messages
302
Solutions
4
Reaction score
42
Points
160
Sin$
7
IMO you need to be really good at soldering, the board & components are so much smaller than you think. Good luck
 
P

Primerchevy

Newbie
Messages
4
Reaction score
3
Points
30
Sin$
7
I'm with gunn1e. I just finished my first RGH 1.2 on a Jasper and going into it i thought i was pretty good at soldering. Even though i was eventually successful it was much more difficult than i though. If you have an old computer motherboard or something with a lot of very small smd components on it to practice on it will help a lot. Find the tiniest most seemingly impossible solder pad with lots of smd components close to it and attempt to solder a wire to it without bridging or loosening any components and thats about what your in for.
 
Top Bottom
Login
Register