What's new

Solved RGH Wont turn on

RealVin

RealVin

Newbie
Messages
8
Reaction score
0
Points
10
Sin$
0
Hello,
I just recently just started to have problems with my RGH. I'm not that smart when it comes to errors, and troubleshooting. When i went to turn my RGH on, it lights up the power ring, but nothing else happens, i tried leaving it there to sit for a few minutes but nothing. I also reconnected both the hdmi and the power brick. Any help would be so nice!
 
Noobert

Noobert

RGH/Flashing Support
VIP
Retired
Trifecta Scaling the Mountain Mythical Veteran
Messages
8,382
Reaction score
4,645
Points
2,315
Sin$
0
Hello,
I just recently just started to have problems with my RGH. I'm not that smart when it comes to errors, and troubleshooting. When i went to turn my RGH on, it lights up the power ring, but nothing else happens, i tried leaving it there to sit for a few minutes but nothing. I also reconnected both the hdmi and the power brick. Any help would be so nice!
If you hit the Eject button to boot, does it boot into Xell?
 
rynax

rynax

Enthusiast
Messages
178
Solutions
1
Reaction score
13
Points
80
Sin$
7
So you mean the green led on the console's RF module is on?
Does the power supply's led turn green or stays orange/red?
Does the fan spin?
No debug led blinking on the glitch board?
 
A video showing the console been turned on as well as the glitch board's status if you could do it
 
RealVin

RealVin

Newbie
Messages
8
Reaction score
0
Points
10
Sin$
0
So you mean the green led on the console's RF module is on?
Does the power supply's led turn green or stays orange/red?
Does the fan spin?
No debug led blinking on the glitch board?
 
A video showing the console been turned on as well as the glitch board's status if you could do it


The fan doesn’t pin, the block blinks red for a second then goes orange.
 
rynax

rynax

Enthusiast
Messages
178
Solutions
1
Reaction score
13
Points
80
Sin$
7
Sounds like the STBY_CLK line has problem if you have a Trinity motherboard.
Either that trace is damaged or the resistor R3B15 on that trace has blown out.
It's likely your soldering to that trace/resistor is not very good or it is half damaged before, when time goes by,
now it has damaged and won't turn on at all, no fan spin, PSU won't turn on.
 
RealVin

RealVin

Newbie
Messages
8
Reaction score
0
Points
10
Sin$
0
Sounds like the STBY_CLK line has problem if you have a Trinity motherboard.
Either that trace is damaged or the resistor R3B15 on that trace has blown out.
It's likely your soldering to that trace/resistor is not very good or it is half damaged before, when time goes by,
now it has damaged and won't turn on at all, no fan spin, PSU won't turn on.

Oh ok, so without getting inside the RGH, i can’t fix?
 
rynax

rynax

Enthusiast
Messages
178
Solutions
1
Reaction score
13
Points
80
Sin$
7
Small chances the PSU is the problem, try another one otherwise you'll have to take it apart and use a multimeter to check the problem
 
Last edited:
ImOx

ImOx

(^._.^)ノ
Retired
Programmer MotM Platinum Record
Messages
9,961
Reaction score
2,963
Points
2,180
Sin$
0
Sorry im not too smart with these terms, what is the PSU and where is it located?
Power Supply Unit, the brick with a light on your power cord.
Also, try removing your hard drive from the console and then booting. Likely wont help here, but just in case.
 
RealVin

RealVin

Newbie
Messages
8
Reaction score
0
Points
10
Sin$
0
Power Supply Unit, the brick with a light on your power cord.
Also, try removing your hard drive from the console and then booting. Likely wont help here, but just in case.

Yeah i just tried that, still nothing. Do i need to get a new brick?
 
Top Bottom
Login
Register