S
Seth1272
Enthusiast
I clicked create ECC, selected my motherboard, and it worked fine to create one. Then I clicked write, and many errors showed up for almost all blocks. Nand-X is configured and plugged in correctly, as I read my NAND earlier many times and they all matched and worked great. Console is plugged in and the power brick is yellow/orange.
J-Runner v0.3 Beta (7):
...
Jasper 16MB Manually Selected
Version: 03
Flash Config: 0x00000000
Can not Continue
--
Worked great for reading NAND before (with same soldering and wiring), and now nothing works. I truly do not believe it is a connection issue, I believe something might be corrupted. Any ideas? This happened on both consoles that I am trying to RGH if that is of any help, I paid very close attention to my soldering on the second one.
Thanks!
J-Runner v0.3 Beta (7):
...
Jasper 16MB Manually Selected
Version: 03
Flash Config: 0x00000000
Can not Continue
--
Worked great for reading NAND before (with same soldering and wiring), and now nothing works. I truly do not believe it is a connection issue, I believe something might be corrupted. Any ideas? This happened on both consoles that I am trying to RGH if that is of any help, I paid very close attention to my soldering on the second one.
Thanks!
Last edited: