What's new

Solved Xbox 360 gets no power. Points for 33ohm resistor?

  • Thread starter ifadedbossx
  • Start date
  • Views 875
I

ifadedbossx

Newbie
Messages
8
Reaction score
0
Points
35
Sin$
7
Whats up guys i got this MW2 jasper that i was rghing and it was working fine till i accidentally burnt a resistor on the southbridge (at least i think i did that) Xbox wouldnt turn on. So i have these 33ohm resistors and i knew some points i could connect to to give the console power. i soldered it to the board and console started working again. i finshed rghing and after one of the points came loose from the resistor and the console wouldnt get power again. ugh. i got it back on and off a couple of times trying hot glue but it wouldnt permanently stay. ended up re soldering so much that i burnt the point. was wondering if there was any other points for the resistor. i know actual xbox still has power cause the coolrunners red light is on when i plug in the console but i cant physically turn on the console. Any help or suggestions would be appreciated!
 
Noobert

Noobert

RGH/Flashing Support
VIP
Retired
Trifecta Scaling the Mountain Mythical Veteran
Messages
8,382
Reaction score
4,645
Points
2,315
Sin$
0
Whats up guys i got this MW2 jasper that i was rghing and it was working fine till i accidentally burnt a resistor on the southbridge (at least i think i did that) Xbox wouldnt turn on. So i have these 33ohm resistors and i knew some points i could connect to to give the console power. i soldered it to the board and console started working again. i finshed rghing and after one of the points came loose from the resistor and the console wouldnt get power again. ugh. i got it back on and off a couple of times trying hot glue but it wouldnt permanently stay. ended up re soldering so much that i burnt the point. was wondering if there was any other points for the resistor. i know actual xbox still has power cause the coolrunners red light is on when i plug in the console but i cant physically turn on the console. Any help or suggestions would be appreciated!
Can you take a clear in focus picture of the point you're referring to? Then upload it to imgur and post the link here.
 
I

ifadedbossx

Newbie
Messages
8
Reaction score
0
Points
35
Sin$
7
i was hoping theres somewhere else i could solder it. or a different way to get power 



thats how i know the mother board still gets power. just dosent turn on
 
I

ifadedbossx

Newbie
Messages
8
Reaction score
0
Points
35
Sin$
7


i circle the point. can't seem to get the wire to stay connected. i got it connected last night again and finished installing leds on the console then the wire came disconnected again. 
better pic
 
HuskerHeaven

HuskerHeaven

when I took his glass of champagne...
Retired
Messages
8,249
Reaction score
3,370
Points
1,680
Sin$
7
It looks like you have about 4 points lifted, points that aren't normally lifted. You would need to find a working board and a meter to figure where to repair it to. Best bet to just use it as a practice board, then toss it.
 
Top Bottom
Login
Register