Xbox Controller disassembly

Discussion in 'Xbox 360' started by OMGitstheBishop, Jun 28, 2009 with 4 replies and 253 views.

Thread Status:
Not open for further replies.
  1. OMGitstheBishop

    OMGitstheBishop Enthusiast

    Messages:
    391
    Ratings:
    233
    Does anyone know how to open up a wireless controller without using a tamper proof torx 8 screwdriver? I have a set of torx ranging from 5 to 10 but none of them are tamper proof. Thanks

     
  2. Sfunx

    Sfunx Enthusiast

    Messages:
    371
    Ratings:
    43
    Get a Torx 8 Security driver, not sure where to get em, friend gave me his. Or you could just get a tiny flat head and try to squeeze it between the peg and the wall. But I wouldn't recommend that.
     
  3. OP
    OMGitstheBishop

    OMGitstheBishop Enthusiast

    Messages:
    391
    Ratings:
    233
  4. xbh1h2

    xbh1h2 Getting There

    Messages:
    1,626
    Ratings:
    175
    That's what I did, I used a tiny flat head, after turning it enough it just wore down the peg and I was able to get in there with a torx.
     
  5. gcnd0001

    gcnd0001 Enthusiast

    Messages:
    383
    Ratings:
    12
    I used a 2mm flathead. It fits perfectly until the peg breaks then you can use a normal T8
     

Share This Page

Thread Status:
Not open for further replies.