I
ifadedbossx
Newbie
Whats up guys i got this MW2 jasper that i was rghing and it was working fine till i accidentally burnt a resistor on the southbridge (at least i think i did that) Xbox wouldnt turn on. So i have these 33ohm resistors and i knew some points i could connect to to give the console power. i soldered it to the board and console started working again. i finshed rghing and after one of the points came loose from the resistor and the console wouldnt get power again. ugh. i got it back on and off a couple of times trying hot glue but it wouldnt permanently stay. ended up re soldering so much that i burnt the point. was wondering if there was any other points for the resistor. i know actual xbox still has power cause the coolrunners red light is on when i plug in the console but i cant physically turn on the console. Any help or suggestions would be appreciated!