What's new

Solved Xbox 360 Ace v3 Trinity Dual Nand

D

Dumman59

Newbie
Messages
66
Reaction score
0
Points
45
Sin$
7
I just recently rgh my trinity and installed a viper chip. Had some issues so I redid my wiring and now it works fine. I wired the wire to the rf board and use the standard led on it. It works as a debug led, but when it boots it does not work. It does not light up during boot or when a controller is connected.
 
Newsk

Newsk

Contributor
Messages
2,602
Solutions
5
Reaction score
348
Points
350
Sin$
7
Best bet would be to add an led . Scratch pcb coating off in a spot between 2 of the leds and add a bit of solder . Then attach the negative side (cathode) to that solder and the wire to the positive side(anode) .

Think I have examples of this in my dual nand guides here on the site.
 
Top Bottom
Login
Register