What's new

Unsolved Unable to boot xell, ace v5

  • Thread starter Paolo7297
  • Start date
  • Views 102
P

Paolo7297

Newbie
Messages
2
Reaction score
0
Hi! I managed to rgh my corona v3.
Connected the jr programmer, dumped the nand and flashed xell.
Next i moved installing ace v5.
During the installation i burned the r2c7 pads so i used an alternative point on the back.
I double (and triple) checked all of the soldering, used alternatives for D and E, but it doesn't boot... It stay on green ring and after some time it turns red (not everytime)
What can i try?
There's a way to check that postfix is okay?
And also for c1 and c2, are them connected to a side for each component? Is it right? I don't know what to do...
 
G

gunn1e

Newbie
Messages
31
Reaction score
5
Please show some pics & we can go from there bud.
 
P

Paolo7297

Newbie
Messages
2
Reaction score
0
I found the problem! there was no resistance between post out from postfix and ground, so i uninstalled then reinstalled some times, after them, it worked!
 
G

gunn1e

Newbie
Messages
31
Reaction score
5
Hey nice, watch those adapters some seem to fit better than others, 50-60ohm is a good reading om a mustimeter.
 
Top Bottom