Here is the link to where i got the origional tutorial. How to make a Rapid Fire controller and the programmer! This tutorial will work with call of duty 5. Works on any controller! Stage 1: Building the Programmer Required: For the rapid Fire chip you must have a 12f683 8-bit chip. They can be bought online. Use google. Soldering iron 15-30W Solder 30AWG wire N-channel MOSfet ( Bs170 or similar) Resistor 10K Resistor 22K Resistor 2.2k Leds 3-5MM (Optional) Socket 8 pin for the chip (recommended but optional RS232 (serial) female socket (also known a D69 or somthinng like that at radioshack) OK that said here is the schematic for the programmer pretty straight Forward...Depending if you are going to use leds, i did...it tells you power and read/write... Here is the one i made with slight modification to the diagram because i like to keep it neat... Testing to see if it works It works!!!! you only to to plug in the USB it test the Mosfet... Step 2: Programming Download and install the following... ( Beezy 4 sheezy's Upload) RapidShare: Easy Filehosting Depending on the style of Rapid fire you want either 1. Sleeper not cutting or drilling required the controller looks totally stock has 3 mode.. mode1= Halo 3 dual trigger Mode2= Cod 5 WAW Mode3= insane fast Cod4 2. Rapidfire RF you have to install 2 buttons one for each trigger (only to change mode you will not actually use it to fire) .This one has the ability to enable/disable rapidfire on each trigger independently...you can also have different moded in bot triggers at once, eg.. Left Trigger Halo3 speed, Right trigger Cod4 speed, Left trigger Cod5 speed right trigger halo3 Speed, so on and son on... Mode1= Halo3 speed Mode2= Cod5 Speed Mode3= Cod4 speed fast Mode4=cod4 Ultrafast of once you have got the above programs installed ... Open Win PIC make sure your programmer in connected... you might have to choose English from the second last menu item thing at the top... go to Settings>Hardware> Choose JDM Programmer and Select your com port and select APPLY...Test hardware by pressing (Ctrl+T) Now You are ready for programming...Make sure you have Pic12F683 selected at the top right hand corner. Open the Hex File (File>Open), (either RapidfireRF.hex or Sleeper.hex) depending on the style you are going to be modding it... Then simply got to. Device>Program All ( ctrl+P ) DONE now You are Ready to Put it in your Controller Stage 3: Installation Sleeper Install OK First Determine if you have a matrix or CG Controller... Wire according to this diagram Resistor Not Required. (the 1k OHM) Both controllers it just protects the led from not burning out in the long run) CG Sleeper Matrix Sleeper Rapid Rf install oK if you have decided to do the Rapid rf install here is how you wire the Controller........ If you have a CG controller If you have a Matrix Controller You can Thank Me for the codes If you want since I really don't see them anywhere else. Just for the best site on the Net. - Beezy Got this from xbox-scene and is NOT my tut just revised it.