What's new

Solved Some questions About Flashing a DVD Drive and Fixing RROD

  • Thread starter ze alpaca
  • Start date
  • Views 866
Z

ze alpaca

Newbie
Messages
4
Reaction score
0
Points
35
Sin$
0
Is there a way to put a new DVD drive in an Xbox because when I put a drive from a diffrent Xbox it just reads my games as a DVD not a game. Had Lite-on switched to the one with 2 black wires.

I have done the XClamp fix and the Penny trick on my Xbox and it still RROD's is there a way to fix it by re-soldering the GPU or is it not the GPU if that doesn't fix it.
 
S

Shartshooter

Enthusiast
Messages
68
Reaction score
6
Points
55
Sin$
0
You need to spoof the dvd drive's dvd key and firmware to that of your original drive then it should work. As for the RROD I'm not sure, x-clamp fix always worked for me.
link: how to spoof
 
decima7e

decima7e

Contributor
Messages
1,844
Reaction score
949
Points
315
Sin$
0
Swap the Pcb's (if you can) so you don't need to flash the drive.

Tell us the secondary error code if you want help with RROD

--==SECONDARY ERROR CODES==-
The specific type of hardware failure can be determined by a "hidden" error code
Turn the xbox 360 on, and wait till the 3 red lights are flashing.
Press and hold the sync up button (the small white one), while holding that button press the eject button.
The LEDs will now blink the first number in the code (as described below).
Release the eject button and press it again.
The LEDs will now blink the second number of the code.
Release the eject button and press it again.
The LEDs will now blink the third number of the code.
Release the eject button and press it again.
The LEDs will now blink the forth number of the code.
Release the eject button and press it again.
The LEDs will go back to the 3 red flashing lights.
You should be able to determine the difference between the 3 flashing lights and the error code lights by the rate in which they flash.

Here is how you interpret the LEDs to get the code number:
All four lights flashing - 0
One light flashing - 1
Two Lights flashing - 2
Three lights flashing - 3
 
Z

ze alpaca

Newbie
Messages
4
Reaction score
0
Points
35
Sin$
0
Error code was
4 lights 1 light 4 lights 2 lights

0102 or the afrerdawn thread says 0103 but both are GPU/CPU connection issues
 
decima7e

decima7e

Contributor
Messages
1,844
Reaction score
949
Points
315
Sin$
0
ze alpaca said:
Error code was
4 lights 1 light 4 lights 2 lights

0102 or the afrerdawn thread says 0103 but both are GPU/CPU connection issues

If you have a heat gun go look up a tut on youtube on how to heat gun an xbox.

If you don't, hold a blow dryer over the gpu/ram chips/cpu until for about 10 min.

(hair dryer about 2 in. away from chips)

Try and xclamp repair as well if the heat gun/blow dryer fails.
 
decima7e

decima7e

Contributor
Messages
1,844
Reaction score
949
Points
315
Sin$
0
I would do both. Never do the backside if you don't have the heatsink or something holding the chip down though. (It falls out if it gets too hot lol)
 
Top Bottom
Login
Register