1. Data Breach Warning!

    In case you aren't aware, there has been an extremely large date breach of emails and passwords posted online! This is just a warning to check and ensure that all of your personal accounts are secure and for you to update passwords where necessary!

    You can check your emails and passwords here to see if they are apart of the dump, but we would recommend updating passwords as a precaution!

    Please also ensure that 2FA is enabled on your account(s)! You can add it to your Se7enSIns account here!
    Dismiss Notice

soldering question on jtag

Discussion in 'Xbox 360 Support Archive' started by Z89, Feb 4, 2010 with 1 replies and 259 views.

Thread Status:
Not open for further replies.
  1. Z89

    Z89 Xbox Modification/Repair Master

    Messages:
    1,555
    Ratings:
    893
    will the solder between two solder points touching make the jtag connections not work...because im having a hard time soldering 3 pts that are next to each other without them touching.

    Thanks

     
  2. MadLittleMods

    MadLittleMods Enthusiast

    Messages:
    1,221
    Ratings:
    232
    haven't done but I think it would matter a lot. Look on the back of the motherboard... Are the points bridged together... if so then doesn't matter.

    Get a solder sucker and just remove all of it and try again(the solder sucker look like this... in spoiler)
    [​IMG]
     

Share This Page

Thread Status:
Not open for further replies.