What's new

Solved Ripped resistor off

  • Thread starter SiimPlisticModz
  • Start date
  • Views 381
S

SiimPlisticModz

Enthusiast
Messages
50
Reaction score
2
I was installing an ace v3 on a trinity and well went to do the CPU reset and my iron Ig was a little to hot and I pulled the CPU rst resistor right off
 
H

HuskerHeaven

when I took his glass of champagne...
Staff
Messages
8,251
Reaction score
3,380
I was installing an ace v3 on a trinity and well went to do the CPU reset and my iron Ig was a little to hot and I pulled the CPU rst resistor right off
Post a picture of the damage please.
 
S

SiimPlisticModz

Enthusiast
Messages
50
Reaction score
2
Post a picture of the damage please.

The r4d4 resistor is broke off but I bridged the 2 points and I'm using an alt post out and CPU rst as this is a repair but idk how to handle the to points.. Do I bridge them or connect them with a peice of wire? I just need to know what I got to do
https://ibb.co/eYACs5
 
N

Newsk

Contributor
Messages
2,505
Reaction score
330
is the stock nand back on the console? also remove 5v wire from ace. if still just beeping you may need to replace the resistor rather than bridging it. not sure cause always been super careful with that resistor. next time just take the time to lift the xclamp and use the giant c5r11 point underneath!!
 
Top Bottom