What's new

Question RGH3 (Stuck)

  • Thread starter Benjjzxcv
  • Start date
  • Views 853
B

Benjjzxcv

Enthusiast
Messages
68
Reaction score
4
Points
55
Sin$
0
I’m currently doing a Corona 16MB RGH3

I have wire the nand read it twice both match then wire the back post and pll point with the QSB then Created ECC then wrote it then booted Xell and got my CPU key then Created XeBuild Image then wrote Nand and now the display on my Tv won’t work tried 3 hdmi’s plus AV and it won’t boot into Xell anymore too

Hope someone can help
 
Last edited:
B

BluesMan67

Enthusiast
Messages
583
Solutions
18
Reaction score
98
Points
150
Sin$
7
Reflash your "Stock/Original" nand dump back to the console, remove RGH 3 wires from the board then test to see if it boots to stock dashboard.
 
B

Benjjzxcv

Enthusiast
Messages
68
Reaction score
4
Points
55
Sin$
0
I used a QSB I think it will f*** everything up if I take that off
 
B

BluesMan67

Enthusiast
Messages
583
Solutions
18
Reaction score
98
Points
150
Sin$
7
I used a QSB I think it will f*** everything up if I take that off
Just de-solder any wires from the QSB. Once those are removed along with the RGH 3 wires and you've re-flashed the "Stock/Original" nand back. then test to see if your console boots to dashboard.
 
B

Benjjzxcv

Enthusiast
Messages
68
Reaction score
4
Points
55
Sin$
0
I’ll try it but I don’t think I have original nand as I rewrite over it when I closed j runner
Post automatically merged:

Just gonna try use a donor nand just got it back to boot to Xell
 
Last edited:
B

Benjjzxcv

Enthusiast
Messages
68
Reaction score
4
Points
55
Sin$
0
I got it back to Xell then it did the same thing so I did it again and used the updflash.bin on Xell and did it that way seem todo the trick
 
Top Bottom
Login
Register