Cutotopo
Newbie
Hello.
Following jointheresistance's tutorial on this site I soldered the cables to my console's motherboard and flashed the ECC and the timing file using a J-R Programmer and a TX Coolrunner Rev3, but I can't boot to Xell to read my CPU Key. The solderings seem to be good but when I press the power button on the RF module the console does not start up. What can I do?
Thanks in advance.
Following jointheresistance's tutorial on this site I soldered the cables to my console's motherboard and flashed the ECC and the timing file using a J-R Programmer and a TX Coolrunner Rev3, but I can't boot to Xell to read my CPU Key. The solderings seem to be good but when I press the power button on the RF module the console does not start up. What can I do?
Thanks in advance.
Last edited: