S
seadanzig
Newbie
jr programmer reading writting nand after wrong nand flash
hi guys ive been given a falcon 360 with a bad flash(got original .bin)
with j r programmer plugged in and xbox plugged in(not turned on)
j runner doesnt recognise controller. which i presume is due to bad flash.
ive tried shortings pins on the nand which didnt work.
so ive tried the 5 volt trick only at 5 volts still same no nand controller
ive lowered the voltage on my bench power supply to 1.9 volts
i get
junner log
================================================== =
15 February 2014 20:28:20
J-Runner v0.3 Beta (4) Started
It's advised to run in administrator mode on Windows 8
Checking Files
Finished Checking Files
Version: 01
Flash Config: 0xFFFFFFFF
IoTimedOut
IoTimedOut:No more bytes!
FFFFFFFF
Falcon Manually Selected
Reading Nand to C:\Users\seadanzig\Desktop\jrunne\J-Runner\output\nanddump1.bin
Reading Nand
IoTimedOut
IoTimedOut:No more bytes!
any reason why the flash config changes from 0x00000000 at 5 volts then 0xffffffff at 1.9volts
ive also used a diy usb programmer too so i know the jrp is not knackered
ready to get my progskeet out shortly but just wanted input from you guys first
cheers neil
hi guys ive been given a falcon 360 with a bad flash(got original .bin)
with j r programmer plugged in and xbox plugged in(not turned on)
j runner doesnt recognise controller. which i presume is due to bad flash.
ive tried shortings pins on the nand which didnt work.
so ive tried the 5 volt trick only at 5 volts still same no nand controller
ive lowered the voltage on my bench power supply to 1.9 volts
i get
junner log
================================================== =
15 February 2014 20:28:20
J-Runner v0.3 Beta (4) Started
It's advised to run in administrator mode on Windows 8
Checking Files
Finished Checking Files
Version: 01
Flash Config: 0xFFFFFFFF
IoTimedOut
IoTimedOut:No more bytes!
FFFFFFFF
Falcon Manually Selected
Reading Nand to C:\Users\seadanzig\Desktop\jrunne\J-Runner\output\nanddump1.bin
Reading Nand
IoTimedOut
IoTimedOut:No more bytes!
any reason why the flash config changes from 0x00000000 at 5 volts then 0xffffffff at 1.9volts
ive also used a diy usb programmer too so i know the jrp is not knackered
ready to get my progskeet out shortly but just wanted input from you guys first
cheers neil