What's new

Solved RGH install help. + reward

OTL

OTL

Enthusiast
Messages
109
Reaction score
44
Points
85
Sin$
0
Hey everyone,

When I select write .ecc it goes as the following;

Version: 01
Flash Config: 0x00023010
Writing Nand
image_00000000.ecc
Failed to write 0x0 block
ext through all the blocks.
I've check my soldering multiple times and I have no bad blocks; any guidance would be helpful and rewarded with $5 USD.​
 
J

JoinTheResistance

Dead to the world, alive for the journey...
Messages
4,669
Reaction score
1,100
Points
1,045
Sin$
7
If you're using a matrix nand flasher or a similar PIC based nand flasher, the errors are caused by a bug and should be ignored.
 
SMPTE

SMPTE

Enthusiast
Messages
210
Reaction score
10
Points
80
Sin$
7
If you're using a matrix nand flasher or a similar PIC based nand flasher, the errors are caused by a bug and should be ignored.

I can read the nand perfectly fine, but I can't write, I get failed to write 0x1c1, etc... Do I just ignore and write as I should?

I'm also using a matrix nand reader/writer.
 
J

JoinTheResistance

Dead to the world, alive for the journey...
Messages
4,669
Reaction score
1,100
Points
1,045
Sin$
7
I can read the nand perfectly fine, but I can't write, I get failed to write 0x1c1, etc... Do I just ignore and write as I should?

I'm also using a matrix nand reader/writer.
Yes, ignore it an continue. As long as you were able to read the nand, you should be fine.
 
Top Bottom
Login
Register