Solved RGH install help. + reward

[OTL]

Hey everyone,

When I select write .ecc it goes as the following;

Version: 01
Flash Config: 0x00023010
Writing Nand
image_00000000.ecc
Failed to write 0x0 block
ext through all the blocks.
I've check my soldering multiple times and I have no bad blocks; any guidance would be helpful and rewarded with $5 USD.​

 

[HuskerHeaven]

Post pictures of your install.

 

[JoinTheResistance]

If you're using a matrix nand flasher or a similar PIC based nand flasher, the errors are caused by a bug and should be ignored.

 

[SMPTE]

If you're using a matrix nand flasher or a similar PIC based nand flasher, the errors are caused by a bug and should be ignored.

I can read the nand perfectly fine, but I can't write, I get failed to write 0x1c1, etc... Do I just ignore and write as I should?

I'm also using a matrix nand reader/writer.

 

[JoinTheResistance]

I can read the nand perfectly fine, but I can't write, I get failed to write 0x1c1, etc... Do I just ignore and write as I should?

I'm also using a matrix nand reader/writer.

Yes, ignore it an continue. As long as you were able to read the nand, you should be fine.

 

[SMPTE]

Yes, ignore it an continue. As long as you were able to read the nand, you should be fine.

Yeah worked all good, was extremity baffled lol, redone the soldering 3 times but was suspicious that it was reading ok.

 

[JoinTheResistance]

Yeah worked all good, was extremity baffled lol, redone the soldering 3 times but was suspicious that it was reading ok.

Good to know you got it working.