What's new

Question RGH (Ace V3) Programming

H

Houston5

Newbie
Messages
1
Reaction score
0
Points
10
Sin$
0
I have dumped the nand and compared both. They are both the same. I then proceeded to create the ecc and write the ecc to the console. After that, I was about to program the chip(Matrix). However when I put the 6 pin header into the chip, it disconnects my nand X programmer. I have tried another chip(ace v3) I had laying around and it does the same thing. I tried to do it on another computer in case it was my computer and it disconnects on another computer as well. This is really the only console I’ve tried to Rgh and need some further guidance on what I am doing wrong. But I would greatly appreciate some help and guidance on this so I don’t ruin this console.
 
Top Bottom
Login
Register