What's new

Solved Removing jtag

  • Thread starter Dingus_12
  • Start date
  • Views 223
D

Dingus_12

Newbie
Messages
2
Reaction score
0
I'm about to install jtag via usb and of course it means i can't use my xbox 360 to play online. Is there a way to remove jtag without having my xbox get detected and banned when playing online in the future?

I know jtag can be used to play online with mods and stuff but I'm asking if i can go back to legit
 
B

BluesMan67

Enthusiast
Messages
346
Reaction score
40
Dingus_12.You can't install a Jtag via/using USB.It's a hardware installation mod (using 2x diodes and a few wires) so you have to get your soldering equipment out to do it.
Plus you need either an Xecuter Nand-X or an Xecuter JR-Programmer in order to read and write to the consoles/motherboard nand chip.
Check what dashboard your console is currently on as the Jtag hack ended on dashboard version 2.0.7371.0 (and that's if the CB hasn't been patched) any dashboard later than 7371 your going to need to carry out the Reset Glitch Hack but with this your going to need to buy a glitch chip (Ace v3 or Matrix or cloned Xecuter Rev C).
You can revert back to a stock nand from either a Jtag or RGH as long as you kept your original nand dumps safe (backed up on another drive or disc or USB pen drive) then you can reflash that original nand dump image back to the consoles nand chip,remove the Jtag diodes and wires(if indeed you did the Jtag hack on a really old version dashboard) or if you did the RGH hack,then just desolder all the wires that you have soldered to the 360 motherboard from the glitch chip and reflash your original backed up nand dump image back to the consoles nand chip using your programmer.Then your back to a stock/unmodded console again.
 
D

Dingus_12

Newbie
Messages
2
Reaction score
0
Dingus_12.You can't install a Jtag via/using USB.It's a hardware installation mod (using 2x diodes and a few wires) so you have to get your soldering equipment out to do it.
Plus you need either an Xecuter Nand-X or an Xecuter JR-Programmer in order to read and write to the consoles/motherboard nand chip.
Check what dashboard your console is currently on as the Jtag hack ended on dashboard version 2.0.7371.0 (and that's if the CB hasn't been patched) any dashboard later than 7371 your going to need to carry out the Reset Glitch Hack but with this your going to need to buy a glitch chip (Ace v3 or Matrix or cloned Xecuter Rev C).
You can revert back to a stock nand from either a Jtag or RGH as long as you kept your original nand dumps safe (backed up on another drive or disc or USB pen drive) then you can reflash that original nand dump image back to the consoles nand chip,remove the Jtag diodes and wires(if indeed you did the Jtag hack on a really old version dashboard) or if you did the RGH hack,then just desolder all the wires that you have soldered to the 360 motherboard from the glitch chip and reflash your original backed up nand dump image back to the consoles nand chip using your programmer.Then your back to a stock/unmodded console again.

I'm talking about this method which basically means you can install the games from usb no wiring and no chips
Post automatically merged:

Just realized the xbox must be modded before hand. Thanks anyways
 
Last edited:
Top Bottom