Reading bank 0 freezes

Discussion in 'Xbox 360 Support Archive' started by ugotpwned5, Jan 20, 2009 with 2 replies and 721 views.

Thread Status:
Not open for further replies.
  1. ugotpwned5

    ugotpwned5 Enthusiast

    Messages:
    162
    Ratings:
    6
    I finally have received my via 6421 card and sata cable and I installed it and hooked it up and when i run dosflash i receive a problem reading from the banks...when i power cycle to get it to function properly it finally goes through that flicking number 0x(something) then says reading bank 0.. and stays there frozen? Any help? :frown: I have my sata connected to the back port on the sata card what is the best port to use? and what is causing this error?


    [​IMG]
     
  2. Darkaj750

    Darkaj750 Enthusiast

    Messages:
    266
    Ratings:
    21
    Use a new version of Dosflash, i had the exact same problems, upgraded and it worked first time, All you need to do is find your drive, hit a number and hit (W) Write , (R) Read , or (E) erase.
     
  3. OP
    ugotpwned5

    ugotpwned5 Enthusiast

    Messages:
    162
    Ratings:
    6
    Thanks but i solved the problem yesterday. It was the difference in just switching ports on the via 6421 <_< ...pshhhh used the one that shows up on the back of the computer instead the one closest inside the computer.
     
Thread Status:
Not open for further replies.