problem with hacking firmware plz help

Discussion in 'Xbox 360 Support Archive' started by NaaaaaaS, Jan 17, 2009 with 4 replies and 261 views.

Thread Status:
Not open for further replies.
  1. NaaaaaaS

    NaaaaaaS Newbie

    Messages:
    3
    Ratings:
    0
    hello
    i got a sata card from amazon and it looks like this
    [​IMG]

    and i plugged the sata cable witch goes to the 360 in the red area
    is that right or should i plug it somewhere else?

    and my problem is I got the 1st port number from device manager
    and when I put the read command in dosflash it says that i wrote the wrong port number

    a little help plzz :?

     
  2. Distorted Hope

    Distorted Hope Enthusiast

    Messages:
    318
    Ratings:
    30
    it could be that you have bought a card that is incompatible with the xbox 360 dvd drive.
     
  3. OP
    NaaaaaaS

    NaaaaaaS Newbie

    Messages:
    3
    Ratings:
    0
    I waited too long to get it
    the shipping took 15 days because I live in the middle east
    anyway I'll keep trying its too late for going back :S

    thx for the help :smile:
     
  4. tOxiC x

    tOxiC x Member

    Messages:
    656
    Ratings:
    116
    That actually looks like a VIA6421... If it is, it should work... Open up JungleFlasher and look for your port then go into DOS.
     
    • Like Like x 1
  5. Darkaj750

    Darkaj750 Enthusiast

    Messages:
    266
    Ratings:
    21
    I have the exact same card, and all i had to do was go into dos, it finds no drives, turn ur 360 on and then type "Dosflash" and it should find it.
     
    • Like Like x 1
Thread Status:
Not open for further replies.