1. Data Breach Warning!

    In case you aren't aware, there has been an extremely large data breach of emails and passwords posted online! This is just a warning to check and ensure that all of your personal accounts are secure and for you to update passwords where necessary!

    You can check your emails and passwords here to see if they are apart of the dump, but we would recommend updating passwords as a precaution!

    Please also ensure that Two-Step Verification is enabled on your account(s)! You can add it to your Se7enSins account here!
    Dismiss Notice

NEED HELP!! SOLDERING NOW!!!

Discussion in 'Xbox 360 Support Archive' started by Xxoo3DooxX, Feb 6, 2010 with 2 replies and 217 views.

Thread Status:
Not open for further replies.
  1. Xxoo3DooxX

    Xxoo3DooxX The Uni-Modder

    Messages:
    185
    Ratings:
    11
    i am trying to solder my printer cable to my motherboard. as i am ohm'ing out the wires to their corresponding pin locations i cannot come up with wires for pin locations 16, 17, and 18 ??????? all other pin locations i have wires for. I am using a BELKEN F3D508-10 male to male LTP cable ?????



    any help would be greatly appreciated

    thank u guys
     
  2. A E I 0wnz U

    A E I 0wnz U Enthusiast

    Messages:
    801
    Ratings:
    100
    It has to be a 25pin cable, check to make sure
     
  3. OP
    Xxoo3DooxX

    Xxoo3DooxX The Uni-Modder

    Messages:
    185
    Ratings:
    11
    yeah it has 25 pins 11 wires not including the shield ground ??
     

Share This Page

Thread Status:
Not open for further replies.