What's new

Solved Need help can't power on or flash Xbox 360 nand

  • Thread starter bacodude1
  • Start date
  • Views 122
B

bacodude1

Newbie
Messages
6
Reaction score
0
So I've been trying to do a RGH 1.2 install on my jasper 16mb and when i wrote the ecc in Jrunner it said it had completed successfully so I go to power on the console and no light from the power button it's like it's dead so I tried to flash back to stock and got the flash config 0x000000 cannot continue error but my solderings fine I've redone the wires multiple times and still same thing what am I doing wrong?
 
N

Newsk

Contributor
Messages
2,512
Reaction score
331
What glitcher is installed? Can u show some pics of the connections ?
 
B

bacodude1

Newbie
Messages
6
Reaction score
0
What glitcher is installed? Can u show some pics of the connections ?
I've got a matrix glitcher v1 and yes I'll post pictures just give me a second
 
B

bacodude1

Newbie
Messages
6
Reaction score
0
So I found the problem there's a broken pin on the nand any way to fix that or is the board dead?
 
N

Newsk

Contributor
Messages
2,512
Reaction score
331
How in the heck did that happen? U do mean one of the legs off the nand chip correct?
 
N

Newsk

Contributor
Messages
2,512
Reaction score
331
Un bridging is the easy part . Just need some flux and run the iron accRoss them. But broken pins can't really be fixed without replacing the chip .
 
B

bacodude1

Newbie
Messages
6
Reaction score
0
Un bridging is the easy part . Just need some flux and run the iron accRoss them. But broken pins can't really be fixed without replacing the chip .
So I ran the iron over the pins but the solder is still stuck is there something else I'm supposed to do
 
Top Bottom