What's new

Solved Jungleflasher with Benq drive failed. PLEASE HELP

  • Thread starter teobeo94
  • Start date
  • Views 1,290
T

teobeo94

Newbie
Messages
5
Reaction score
0
Points
35
Sin$
0
I connect my drive with a sata cable and powered it with the xbox's power.

No matter what I tried (reboot many times, half tray method, device intro, etc) it still has the no drive detected in the vendor section.

Does anyone know of a way that could help me? btw I am running on 2.0.12625.0 and used JF 0.1.86b if it helps.
 
danmed

danmed

Enthusiast
Messages
450
Reaction score
42
Points
85
Sin$
0
Re-read the jungleflasher instructions. it has very clear instructions on what to do. if you can't get it working then you havn't read it properly.

http://jungleflasher.net/downloads.html

Hints to point you in the right direction :

*Check your sata chipset in your PC and read the guide above.
*Make sure you are booting in the correct order
 
tim008

tim008

Retired Diet Mod
Retired
Messages
9,292
Reaction score
1,871
Points
690
Sin$
7
I connect my drive with a sata cable and powered it with the xbox's power.

No matter what I tried (reboot many times, half tray method, device intro, etc) it still has the no drive detected in the vendor section.

Does anyone know of a way that could help me? btw I am running on 2.0.12625.0 and used JF 0.1.86b if it helps.
If still no luck, contact: Nickelodeon He is the flashing god.
 
Dr Death

Dr Death

Getting There
Messages
1,551
Reaction score
213
Points
190
Sin$
0
I connect my drive with a sata cable and powered it with the xbox's power.

No matter what I tried (reboot many times, half tray method, device intro, etc) it still has the no drive detected in the vendor section.

Does anyone know of a way that could help me? btw I am running on 2.0.12625.0 and used JF 0.1.86b if it helps.

use dosflasher as this can bring back benq drives from the dead most of the time.
 
Top Bottom
Login
Register