JTAG HELP

Discussion in 'PC Support Archive' started by FEAR iTz, Feb 7, 2010 with 4 replies and 124 views.

Thread Status:
Not open for further replies.
  1. FEAR iTz

    FEAR iTz Enthusiast

    Messages:
    521
    Ratings:
    185
    I do not have any video on my JTAG when I turn it on what do I do to fix this.

     
    • Like Like x 1
  2. XsV161

    XsV161 Getting There

    Messages:
    1,478
    Ratings:
    301
    Be more specific... Do you have XBReboot installed? Do you have Xell installed? Do you have the JTAG connections in place?

    FYI these are the JTAG connections.

    Xenon:

    [​IMG]

    Zephyr, Falcon, Opus, Jasper:

    [​IMG]
     
  3. OP
    FEAR iTz

    FEAR iTz Enthusiast

    Messages:
    521
    Ratings:
    185
     
    • Like Like x 1
  4. XsV161

    XsV161 Getting There

    Messages:
    1,478
    Ratings:
    301
    Did you extract and write your kv.bin and config.bin to XBReboot? Did you make sure that you have the correct motherboard revision? If so, then re-download a fresh xbr from xbins and rewrite your kv.bin and config.bin to it then reflash it to your xbox.
     
  5. OP
    FEAR iTz

    FEAR iTz Enthusiast

    Messages:
    521
    Ratings:
    185
    ok I will try this again. I got my xbox last monday did all the wiring and i have been doing this since maybe I just fail i do not know but would it be possible for u to teamview. if not that is ok
     
    • Like Like x 1
Thread Status:
Not open for further replies.