I seriously have tried everything. When I try to run nandpro to read my nand it says could not detect a flash controller. Plz don't tell me to check my wires or soldering because I've double checked to see if the wires are good and i know that my soldering is good. I have everything soldered directly to the board and then i soldered an lpt cable to it. I have a xenon with like a 6 something kernel. My diode is facing towards the motherboard too. If my board is a little black should I maybe try to clean it up with some alcohol or something? I have done this before and got everything working but that box died on me.