What's new

Solved Jasper not getting powered

  • Thread starter TheRedishFire
  • Start date
  • Views 1,309
TheRedishFire

TheRedishFire

Enthusiast
Messages
751
Reaction score
27
Points
120
Sin$
7
I am trying to RGH 1.2 a Jasper and it is plugged in correctly however the console does not turn on and it says
Flash Config: 0x00000000
Can not Continue
in jrunner
 
J

JoinTheResistance

Dead to the world, alive for the journey...
Messages
4,669
Reaction score
1,100
Points
1,045
Sin$
7
TheRedishFire

TheRedishFire

Enthusiast
Messages
751
Reaction score
27
Points
120
Sin$
7
Can't really tell from the pictures, but your soldering looks bad. Desolder everything and see if the console boots. If it does, resolder only the nand read cables, but first trim the leads and use flux. If it doesn't check the CLK point, it might be damaged.
there is no solder on CLK point I pulled on the wire and it lifted however the pad seems to still be there
 
A cow in space

A cow in space

Enthusiast
Messages
33
Reaction score
7
Points
55
Sin$
7
Your best shot would be to re solder and try again , and if that dont work i advise to try and buy a new socket and if that dont work then im clueless XD
 
J

JoinTheResistance

Dead to the world, alive for the journey...
Messages
4,669
Reaction score
1,100
Points
1,045
Sin$
7
Flash Config: 0x00000000
Can not Continue
did not work and the console is getting power
The CLK point looks lifted, no point in trying to read the nand before that's fixed.
If you aren't sure, check for continuity between the points marked in red.
K8_LSM0_F.jpg
 
Last edited:
Top Bottom
Login
Register