What's new

Discussion JASPER 512 RGH 3 NO XELL

  • Thread starter azerzeki
  • Start date
  • Views 1,481
azerzeki

azerzeki

Newbie
Messages
8
Reaction score
0
Points
10
hello to everuone.i ve modded my jasper 512 on rgh 3 using a 10k and a 22k resistor but no way it boots up in xell .have you any solution?
 
azerzeki

azerzeki

Newbie
Messages
8
Reaction score
0
Points
10
hello pictures are here
nFExqBj.jpg
mgqUmXS.jpg
 
gunn1e

gunn1e

Enthusiast
Messages
176
Solutions
3
Reaction score
25
Points
115
Hard to tell from the bad photos, try re routing your wiring perhaps under the clamps, phats can be very fussy, sorry bro thats all i can advise.
 
jfresh401

jfresh401

Newbie
Messages
8
Reaction score
0
Points
35
Try using the 10mHz setting, and just wires. Also an older version of JRunner with the rgh3 options
 
B

BluesMan67

Enthusiast
Messages
555
Solutions
18
Reaction score
95
Points
150
Try also trimming down your wire length as they are far to long and don't route your wires near any component that emits electric interferance (coils).
 
ScHaLL_iTzZ_JoEy

ScHaLL_iTzZ_JoEy

Newbie
Messages
22
Reaction score
0
Points
35
Bro I hope you read this , I used a resistor and diode, but with the diode I would get a boot for 2 seconds and instantly shut off, I removed the diode and soldered wires directly I get instant boots on my falcon everytime now! Have had the console running all day for almost 3 days now NO ISSUES AT ALL 🤞🤞 hope this helps
 
Top Bottom
Login
Register