What's new

Solved J-Runner and JRP 2

  • Thread starter KryptonicDesigns
  • Start date
  • Views 893
K

KryptonicDesigns

Enthusiast
Messages
303
Reaction score
5
So i installed my JRP 2 into my falcon and connected it to my computer, launched J-Runner and this is all i keep getting


Bootloader Attached
Bootloader Version: 1.0.5
Checking Console..
Device Not Found.
Can not continue


someone please help me. i somehow manage to run into every single problem that exists whenever i do anything
 
N

Noobert

RGH/Flashing Support
VIP
Retired
Messages
8,385
Reaction score
4,624
So i installed my JRP 2 into my falcon and connected it to my computer, launched J-Runner and this is all i keep getting


Bootloader Attached
Bootloader Version: 1.0.5
Checking Console..
Device Not Found.
Can not continue


someone please help me. i somehow manage to run into every single problem that exists whenever i do anything
There's a switch on the JR Programmer that says JP-BL.
Push it away from it.
 
K

KryptonicDesigns

Enthusiast
Messages
303
Reaction score
5
There's a switch on the JR Programmer that says JP-BL.
Push it away from it.
Tried it still i get the same message.
Also it has the red Led on i haven't seen the green one on at all
 
K

KryptonicDesigns

Enthusiast
Messages
303
Reaction score
5

Follow that when it says Bootloader Attached.
ok it worked but now i get this

Checking Console..
Version: 10
Flash Config: 0x00000000
Can not Continue
Can not continue

whenever i try to check the motherboard nand type
 
K

Killjoy666

Getting There
Messages
1,649
Reaction score
234
ok it worked but now i get this

Checking Console..
Version: 10
Flash Config: 0x00000000
Can not Continue
Can not continue

whenever i try to check the motherboard nand type
Sounds Like A Soldering Issue.
 
K

KryptonicDesigns

Enthusiast
Messages
303
Reaction score
5
Sounds Like A Soldering Issue.
Still getting this after re soldering and checking over everything
hmm i got bored and opened up the lil JR-P menu and im able to shutdown the console thru it but i simply cant read anything from the nand?
 
Last edited:
K

Killjoy666

Getting There
Messages
1,649
Reaction score
234
Still getting this after re soldering and checking over everything
hmm i got bored and opened up the lil JR-P menu and im able to shutdown the console thru it but i simply cant read anything from the nand?
Try And Solder The Wires From The Bottom.
 
K

Killjoy666

Getting There
Messages
1,649
Reaction score
234
ok 

not sure if this helps but i kept retrying to read the motherboard type and it was able to come up with something rather than Flash Config: 0x00000000 but that was only once
Did You Solder The Wires On The Bottom?
 
K

KryptonicDesigns

Enthusiast
Messages
303
Reaction score
5
Make sure you have the power supply plugged into the xbox, but not turned on. I sometimes forget to do that and I get that flash config error.
Yes it has been plugged in!
 
K

KryptonicDesigns

Enthusiast
Messages
303
Reaction score
5
Before you do anything else, lets see pictures of your current soldering.
Ok heres the photo... unfortunately rosin core solder gives off a glare
 
Top Bottom