What's new

Solved How do I reflow a jtag?

G

GPhone

Getting There
Messages
2,235
Reaction score
348
Does anyone have a TuT for reflowing a jtag
also i have the E20 Error on my jtag
or how do i fix my E20 Error jtag without reflowing?
 
P

ProjectEchoMods

Enthusiast
Messages
396
Reaction score
95
What is the secondary code?
The specific type of hardware failure can be determined by a "hidden" error code
• Turn the xbox 360 on, and wait till the 3 red lights are flashing.
• Press and hold the sync up button (the small white one), while holding that button press the eject button.
• The LEDs will now blink the first number in the code (as described below).
• Release the eject button and press it again.
• The LEDs will now blink the second number of the code.
• Release the eject button and press it again.
• The LEDs will now blink the third number of the code.
• Release the eject button and press it again.
• The LEDs will now blink the forth number of the code.
• Release the eject button and press it again.
• The LEDs will go back to the 3 red flashing lights.
You should be able to determine the difference between the 3 flashing lights and the error code lights by the rate in which they flash.

Here is how you interpret the LEDs to get the code number:
• All four lights flashing - 0
• One light flashing - 1
• Two Lights flashing - 2
• Three lights flashing - 3
1 light = 1
2 lights=2
3 lights=3
4lights=0

Eg. 1433=1033

Do this and repost...

Also, I would not recommend you doing it on a jtag first.
It is hard and complicated.
Get a pro to do it...
 
H

Henickedmysandw

Newbie
Messages
17
Reaction score
1
Reflowing a Jtag'd machine is no different to reflowing a normal 360.
Depending on how you do it you may want to remove the JTAG wires etc.
 
E

etownlax

Getting There
Messages
1,605
Reaction score
192
Reflowing a Jtag'd machine is no different to reflowing a normal 360.
Depending on how you do it you may want to remove the JTAG wires etc.

If you need to do that, you are going to want to reflash the original nand on it so it can boot up, to test if it works properly.
 
Top Bottom