What's new

Solved [Help] [Jtag] error 0022 when flasing xell reloaded ( method diode or aud clamp )

  • Thread starter thanhtrung0111
  • Start date
  • Views 678
T

thanhtrung0111

Newbie
Messages
17
Reaction score
0
This is the fourth jtag falcon.. i damage the first falcon jtag and successful jtag next two falcon.
http://www.se7ensins.com/forums/thr...-xell-reloaded-e71-restore-orig-nand.1278390/
My Console : Falcon
Dashboard: 7363
I decided Jtag it.
Tools: Read nand tools (LPT cable solder ), nandpro 30, jrunner v.03 beta 4

-Reading nand : have one bad block 0x02dc at 0x03FF
- create xell reloaded by jrunner ( without aud clamp ) ; flash falcon.bin to xbox => RROD error e79
- create xell reloaded by jrunner ( with check off aud_clamp and solder from hack_aud_clamp ) ; flash falcon_hack_aud_clamp.bin to xbox => RROD (code 0022 )

How do i do in next step ? Anyone know ? thank first.
 
J

JoinTheResistance

Dead to the world, alive for the journey...
Messages
4,670
Reaction score
1,088
Can you post pics of your soldering? And are you using the aud clamp wiring?
 
H

Hypotoad

Enthusiast
Messages
496
Reaction score
107
Did you check your CB is it 4558?
 
T

thanhtrung0111

Newbie
Messages
17
Reaction score
0
updated: i resolder and use hack_ aud_clamp and flash nand remapped . result is successful . thank all.

I have another question. i continued hacking jtag one other falcon xbox. i read nand, compared 2nand and no bad block. i creat xelloaded without check off aud clamp. then turn on xbox, it rrod e79.
after that , i dont read and write nand continue. nandpro note in cmd : could not detect flash controller.
Then, i resolder but cant continue read nand.
Do Anyone know how to fix it ? Thank first.
 
T

thanhtrung0111

Newbie
Messages
17
Reaction score
0
i dont understand this method clearly, "bridge" and "shorted" mean ? Did it mean put a heat screw driver between four point 44-47 ?
 
J

JoinTheResistance

Dead to the world, alive for the journey...
Messages
4,670
Reaction score
1,088
Put something made of metal between the points, mentioned in that post.
Here is an example picture I took for you.
IMG_0033_Copy.jpg
 
T

thanhtrung0111

Newbie
Messages
17
Reaction score
0
Put something made of metal between the points, mentioned in that post.
Here is an example picture I took for you.
IMG_0033_Copy.jpg
plug psu only or plug psu and press power on? thank. need i unplug lpt cable from pc when doing it?
 
J

JoinTheResistance

Dead to the world, alive for the journey...
Messages
4,670
Reaction score
1,088
Top Bottom