What's new

Solved Help console wont turn on

  • Thread starter miniclip152
  • Start date
  • Views 417
M

miniclip152

Enthusiast
Messages
119
Reaction score
2
Points
70
Sin$
0
I previously jtagged my xbox 360 because I could not install cygnos 360 on the bottom of my motherboard cause the solder pads fell out. So i jtagged it, I was using a LPT cable to flash the nand but it couldnt detect it. I tried fixing the Could not detect flash controller problem but couldnt. So i removed the jtag and sent it in to have cygnos installed but the guy couldnt get it to turn on. I have recieved it and its true it doesnt turn on. Thats probably why it couldnt detect the flash controller. So the problem is most likely in the soldering. The powerbrick light just stays orange. What did i do wrong and how do i fix it?
 
D

dawg insane

Enthusiast
Messages
33
Reaction score
2
Points
55
Sin$
0
any missing wires? or problems with the motherboard? perhaps a bad power box in the system. cuz i only have had a problem with the disc tray but since mine isnt jtagged i sent it into microsoft
 
XsV161

XsV161

Getting There
Messages
1,476
Reaction score
306
Points
190
Sin$
0
Need to short the nand.

Follow this guide: http://forums.afterdawn.com/t.cfm/f-152/how_to_recover_from_a_bad_nand_flash_dead_360-826514/
 
M

miniclip152

Enthusiast
Messages
119
Reaction score
2
Points
70
Sin$
0
Need to short the nand.

Follow this guide: http://forums.afterdawn.com/t.cfm/f-152/how_to_recover_from_a_bad_nand_flash_dead_360-826514/
Ok i tried it not sure if i did it right i bridged all the pins from 44-47 with a tiny screwdriver. Doesnt turn on.
 
Top Bottom
Login
Register