What's new

Solved Going back to RGH2 - RIP RGH 1.2

J

jared911

Newbie
Messages
90
Reaction score
4
Going back to RGH2

every single RGH 1.2 i have done have all booted successfully multiple times
for some reason, when buyer receives it
too many freezing, not booting issues, will freeze and never boot again with RGH 1.2
I use the exact same wire routing, and about half of those shipped have issues once received
too much stress
pretty much all jaspers

never had issues like this with RGH2

Question is, do i just wire the chip as RGH2, program coolrunner?
Is there anything else to do?

thanks
 
R

ravendrow

Newbie
Messages
1
Reaction score
0
are you enabling the 100nf cap on the coolrunner..i have noticed freezing issues if you do...i started using matrix chips because they perform better on RGH1.2
 
J

jared911

Newbie
Messages
90
Reaction score
4
are you enabling the 100nf cap on the coolrunner..i have noticed freezing issues if you do...i started using matrix chips because they perform better on RGH1.2

Nope, i leave the coolrunner stock. It gets depressing when it works fine on my end, then a week later, it's got issues
I have 3 here, that i want to revert back to 2.0
want to know if all to do is wire for 2.0, set jumpers on coolrunner, and program coolrunner?

Where did you order matrix chips from?
 
H

Hypotoad

Enthusiast
Messages
496
Reaction score
107
I used a Matrix V3 on a stubborn Jasper and it works fine with RGH 1.2, maybe there are issues with the Coolrunners that only shows up after some use?
 
Top Bottom