1. Data Breach Warning!

    In case you aren't aware, there has been an extremely large data breach of emails and passwords posted online! This is just a warning to check and ensure that all of your personal accounts are secure and for you to update passwords where necessary!

    You can check your emails and passwords here to see if they are apart of the dump, but we would recommend updating passwords as a precaution!

    Please also ensure that Two-Step Verification is enabled on your account(s)! You can add it to your Se7enSins account here!
    Dismiss Notice

Freeboot question

Discussion in 'Xbox 360 Support Archive' started by kronosslayer, Feb 7, 2010 with 10 replies and 237 views.

Thread Status:
Not open for further replies.
  1. kronosslayer

    kronosslayer Enthusiast

    Messages:
    282
    Ratings:
    21
    once i have freeboot installed, will my disk drive have to be flashed to read unencrypted disks(burned cds)

     
  2. xP1GxB3N1Sx

    xP1GxB3N1Sx Enthusiast

    Messages:
    182
    Ratings:
    34
    no it doesn't but to read burned xbox 360 games then yes it will need to be flashed
     
    • Like Like x 1
  3. OP
    kronosslayer

    kronosslayer Enthusiast

    Messages:
    282
    Ratings:
    21
    Ok so i will be able to install xex loader without trouble?
     
  4. xP1GxB3N1Sx

    xP1GxB3N1Sx Enthusiast

    Messages:
    182
    Ratings:
    34
    yep:smile: i put xex loader on mine without flashed firmware
     
  5. OP
    kronosslayer

    kronosslayer Enthusiast

    Messages:
    282
    Ratings:
    21
    well which do i go with this with diodes[​IMG] or this he says to leave the 330 ohm resistors n it will be jtaged[​IMG]
     
  6. xP1GxB3N1Sx

    xP1GxB3N1Sx Enthusiast

    Messages:
    182
    Ratings:
    34
    i would say go with the diodes
     
  7. OP
    kronosslayer

    kronosslayer Enthusiast

    Messages:
    282
    Ratings:
    21
    n i can dump the nand before jtag right?
     
  8. EclipseModz

    EclipseModz Retired Retired

    Messages:
    7,692
    Ratings:
    2,694
    330 ohm resistors are old and don't work very well.

    Diodes are the way to go.
     
    • Like Like x 1
  9. xP1GxB3N1Sx

    xP1GxB3N1Sx Enthusiast

    Messages:
    182
    Ratings:
    34
    yes people just do both at the same time but it doesnt matter
     
    • Like Like x 1
  10. Sol Invictus

    Sol Invictus Contributor

    Messages:
    2,658
    Ratings:
    552
    ^^
    You got your blue back!!!!!!!! and yes diodes FTW.
     
    • Like Like x 1
  11. OP
    kronosslayer

    kronosslayer Enthusiast

    Messages:
    282
    Ratings:
    21

Share This Page

Thread Status:
Not open for further replies.