Legit Help
Enthusiast
note i am doing this for the 16 megabyte xenon some cmd commands might be different if you have a 256MB or a 512MB nand
and this will fix most problems with freeboot maker
right so if you have xbr(8995) on your jtag and like most people want freeboot(9199)
but every time you want to make a freeboot image you get this
Well if you have a way of reding and writing the nand usb or lpt
Search around for xbr for your motherboard revision
When you have xbr rename the file to xbr.bin a and place in your nand pro folder
Also put the nand you was trying to use with the freboot into the nandpro folder
And rename it to nand.bin
Now open up cmd and type Nandpro nand.bin: -r16 rawkv.bin 1 1 and hit enter
Like so below
Now type NandPro nand.bin: -r16 rawconfig.bin 3de and hit enter like shown below
Now in your nandpro folder there should be the rawkv.bin and raw config.bin
Now what we want to do is inject them into xbr so open up cmd and type
NandPro xbr.bin: -w16 rawkv.bin 1 1
Now do the same for the config so
NandPro xbr.bin: -w16 rawkv.bin
Now open up freeboot maker enter your cpu key and now use the xbr for the image
and baaam there you have a freeboot image ready to flash to your jtag
and this will fix most problems with freeboot maker
right so if you have xbr(8995) on your jtag and like most people want freeboot(9199)
but every time you want to make a freeboot image you get this
Well if you have a way of reding and writing the nand usb or lpt
Search around for xbr for your motherboard revision
When you have xbr rename the file to xbr.bin a and place in your nand pro folder
Also put the nand you was trying to use with the freboot into the nandpro folder
And rename it to nand.bin
Now open up cmd and type Nandpro nand.bin: -r16 rawkv.bin 1 1 and hit enter
Like so below
Now type NandPro nand.bin: -r16 rawconfig.bin 3de and hit enter like shown below
Now in your nandpro folder there should be the rawkv.bin and raw config.bin
Now what we want to do is inject them into xbr so open up cmd and type
NandPro xbr.bin: -w16 rawkv.bin 1 1
Now do the same for the config so
NandPro xbr.bin: -w16 rawkv.bin
Now open up freeboot maker enter your cpu key and now use the xbr for the image
and baaam there you have a freeboot image ready to flash to your jtag