V
v102
Newbie
So I broke the FT2V1 point and looking for an alternative. I read that I also need to bridge the two points next the FT2V1.
So far I have read and written the nand , but cant boot into Xell to get the key. I get a flashing green light.
I found that I can connect C5R3 to FT3R9 instead of the FT2V1.
This is the example I am using
Anybody tried this?
So if I use point FT3R9 Could I use the same ground point for the voltage regulator next to the FT2V1?
So far I have read and written the nand , but cant boot into Xell to get the key. I get a flashing green light.
I found that I can connect C5R3 to FT3R9 instead of the FT2V1.
This is the example I am using
Anybody tried this?
So if I use point FT3R9 Could I use the same ground point for the voltage regulator next to the FT2V1?
Last edited: