What's new

Solved E79... Falcon boots xell but won't boot XBR

XsV161

XsV161

Getting There
Messages
1,476
Reaction score
306
Points
190
Sin$
0
I'm positive my soldering is perfect. I used an alternate point to DB1F1 & FT1U2‎ because the soldering pads are burnt.

My falcon boots up xell just fine, but I get an E79 error message when I boot up with the power button.

When I use the power button to turn it on, the green lights start flashing in a row as if it were booting up properly, but when it gets to the forth light it shoots directly to E79.

I'm probably guessing that it's a soldering issue but I'll upload some pictures so you can tell me what's wrong :smile:

eb97430e.jpg


0613915b.jpg


835dbee5.jpg


4d6170f1.jpg


32ba4ddc.jpg


e991f998.jpg
 
XsV161

XsV161

Getting There
Messages
1,476
Reaction score
306
Points
190
Sin$
0
I've got a bad block in there. 253 I believe. It always says error reading/writing block 253. In eclipsemodz tutorial, he said if you get a 25x read/write error then don't worry about it.

I'm willing to try anything to fix this now, but first I'll try installing a 330 or 470 ohm resistor on the jumper or try installing the jtag wiring the 'new' way.

btw when I start it up, it gets to the xbox 360 logo then goes straight to E79.
 
B

bailw2

Enthusiast
Messages
242
Reaction score
9
Points
70
Sin$
0
I've got a bad block in there. 253 I believe. It always says error reading/writing block 253. In eclipsemodz tutorial, he said if you get a 25x read/write error then don't worry about it.

I'm willing to try anything to fix this now, but first I'll try installing a 330 or 470 ohm resistor on the jumper or try installing the jtag wiring the 'new' way.

btw when I start it up, it gets to the xbox 360 logo then goes straight to E79.

Installing a 330 ohm resistor is not going to help. Instead of soldering the connection to the RL board, try solder it under the motherboard. If that doesn't help, swap out the diodes.
 
XsV161

XsV161

Getting There
Messages
1,476
Reaction score
306
Points
190
Sin$
0
I've already tried soldering to the bottom. I resoldered all of my connections to the bottom. Over @ xs there's a lot of people saying the jumper w/330 ohm resistor helps on the falcon mobo
 
Top Bottom
Login
Register