Solved e74

Discussion in 'Xbox 360 Support' started by AustinPowers, Jul 18, 2011 with 9 replies and 469 views.

  1. AustinPowers

    AustinPowers Wizard

    Messages:
    1,172
    Ratings:
    171
    Ok i wrote a faulty fb image then i got e74 but xell still booted.
    I put my wires back in erased nand/wrote xell/wrote xellous/now what since my orig nand is f***eed?
     
  2. Fire30

    Fire30 Seasoned Member

    Messages:
    7,285
    Ratings:
    2,220
    e-74 is gpu error.... xell is run off the cpu. That is why the xell still works, you need to reflow the gpu
     
  3. E Coli

    E Coli Newbie

    Messages:
    5
    Ratings:
    0
    You may have shorted the motherboad while soldering. I don't think e74 would have to do with what you did.
     
  4. Legacy xZ

    Legacy xZ Enthusiast

    Messages:
    202
    Ratings:
    16
    FML E74 ruined so many of my Xboxs. Back when i never knew how to fix them :') if only i had you people back then
     
  5. E Coli

    E Coli Newbie

    Messages:
    5
    Ratings:
    0
    yea that's true. But if you wan't to reflow the gpu, you have to replace the X-Clamps because once you remove them and put them back on, they wont be tight anymore causing a small gap between the heat sink and GPU, which will cause the thermal paste to melt, which then will lead to burning out the GPU and cause irreversible damage.
     
  6. Fire30

    Fire30 Seasoned Member

    Messages:
    7,285
    Ratings:
    2,220
    so what is your solution lol... to leave the xbox rrod... reflow or reball is the only solution
     
  7. OP
    AustinPowers

    AustinPowers Wizard

    Messages:
    1,172
    Ratings:
    171
    it was fine before i flashed freeboot?
     
  8. Fire30

    Fire30 Seasoned Member

    Messages:
    7,285
    Ratings:
    2,220
    if your orig nand didn't work, than i can guarntee that it is your gpu...
     
  9. OP
    AustinPowers

    AustinPowers Wizard

    Messages:
    1,172
    Ratings:
    171
    My original nand was very messed up....it said i was on dash 60321
    i messed my orig nand up
     
  10. E Coli

    E Coli Newbie

    Messages:
    5
    Ratings:
    0
    Yea reflow it but make sure you have the replacement screws and washers for the XClamps.
     

Share This Page