S
sadpony
Newbie
I am fairly new to Xbox One Consoles, but have been a board level technician for many years. Picked up a few consoles to experiment on, and one of them booted to an E100 error. The error I received was: E100 00000703 80910006. At first I thought it was the HDD, but after poking around the hdd I found a folder on the H: Drive (System Support) called "oddfwupd". in this folder was a bunch of log.txt files and a sequence file. When inspecting the logs I found the following:
I noticed the the "80910006" matched the last chunk of the error code. When inspecting the logs from a workign system, I found:
So it looks like there is an issue with the ODD's firmware, or something failed during the update and that the drive is not being locked. Not sure if this is fixable, any insight would be appreciated.
Code:
ODDFW update sequence: 8.
FOUND DeviceInstance AHCI\Port\0
Got PDO: \Device\00000017
Drive type detected: Elk.
Drive is Unlocked!
Nvkey is Not programmed!
Found firmware FW_0001.bin.
Firmware version match, no FW update is needed
Update is not neccessary.
Drive is Unlocked!
Nvkey is Not programmed!
ODD token found in factory settings, consider ODD is paired.
Invalid lock status detected. Lock = 0, Nvkey = 0, Pair = 1
ODDFW update failed, hr = 80910006, retry again in two seconds.
Found firmware FW_0001.bin.
Firmware version match, no FW update is needed
Update is not neccessary.
Drive is Unlocked!
Nvkey is Not programmed!
ODD token found in factory settings, consider ODD is paired.
Invalid lock status detected. Lock = 0, Nvkey = 0, Pair = 1
ODDFW update failed, hr = 80910006, retry again in two seconds.
Found firmware FW_0001.bin.
Firmware version match, no FW update is needed
Update is not neccessary.
Drive is Unlocked!
Nvkey is Not programmed!
ODD token found in factory settings, consider ODD is paired.
Invalid lock status detected. Lock = 0, Nvkey = 0, Pair = 1
ODDFW update failed, hr = 80910006, retry again in two seconds.
ODDFW update finished, hr = 80910006
I noticed the the "80910006" matched the last chunk of the error code. When inspecting the logs from a workign system, I found:
Code:
ODDFW update sequence: 9.
FOUND DeviceInstance AHCI\Port\0
Got PDO: \Device\00000016
Drive type detected: Elk.
Drive is Locked!
Nvkey is Programmed!
Found firmware FW_0001.bin.
Firmware version match, no FW update is needed
Update is not neccessary.
Drive is Locked!
Nvkey is Programmed!
ODD token found in factory settings, consider ODD is paired.
PV+ console already locked, skip lock down.
Got drive auth status : 2
ODDFW update finished, hr = 00000000
So it looks like there is an issue with the ODD's firmware, or something failed during the update and that the drive is not being locked. Not sure if this is fixable, any insight would be appreciated.
Last edited: