O
ozzylow
Enthusiast
After a day of the Vault case, I have already got sick of it, time to start some work on the case, still thinking of a theme or design. I bought another Urban Blue Vault and the Battlefield 3 Edition also.
Dremel Time
Sanded back the holes with the dremel, helps with the filler something to adhere to
The stand is slightly raised up because of the rubber pads underneath. Just enough of a gap to install some LED's inside the feet for a glowing stand. These should be powered by a USB port so no need to open your Xbox for a power source, I want this case to be able to be attached to anyone's Xbox 360 Console.
Filler over the holes, will sand back and then apply another thin layer. As always less is more, you do not want to be sanding filler all day.
Base in primer, the small holes / indents above each foot, I will fill these as it does not fit with the rest of the design.
Dremel Time
Sanded back the holes with the dremel, helps with the filler something to adhere to
The stand is slightly raised up because of the rubber pads underneath. Just enough of a gap to install some LED's inside the feet for a glowing stand. These should be powered by a USB port so no need to open your Xbox for a power source, I want this case to be able to be attached to anyone's Xbox 360 Console.
Filler over the holes, will sand back and then apply another thin layer. As always less is more, you do not want to be sanding filler all day.
Base in primer, the small holes / indents above each foot, I will fill these as it does not fit with the rest of the design.