Solved Controller won't start up after take apart

[JenkinsThePole]

I took apart my controller to switch the LED and long story short I burnt the pads off but I got the LED on by making leads from the led to the little black dot that I scraped at. Anyways now it won't start up with batteries or a cord and solutions?

 

[Space]

HD photo of the burnt parts?

 

[JenkinsThePole]

HD photo of the burnt parts?

Sorry I took so long

 

[JenkinsThePole]

I removed the LED to see the pads better. Also how hard is it to fix a burnt pad like this because Ive been at it for a few hours now.

 

[Red]

I removed the LED to see the pads better. Also how hard is it to fix a burnt pad like this because Ive been at it for a few hours now.

It looks like the solder is touching the board as well as the points, try and make sure that it is not, since it could be shorting

 

[JenkinsThePole]

It looks like the solder is touching the board as well as the points, try and make sure that it is not, since it could be shorting

How would I do that because the solder has to stretch far enough to to fit the led