What's new

Solved 79

  • Thread starter eastonhockey5
  • Start date
  • Views 302
E

eastonhockey5

Newbie
Messages
2
Reaction score
0
Points
35
Sin$
0
after I backed up my nand and flashed a modded one, my xbox gives an e79 error and one red light (bottom right). I flashed back to the original nand and I get the 3 red lights. I have a falcon motherboard. any ideas would be greatly appreciated, thanks.
 
N

NewbieShwa

Enthusiast
Messages
161
Reaction score
4
Points
70
Sin$
0
this happened to me when one of the Jtag wires, was touching each other... just make sure none your your wires are touching our conducting
 
tripp419

tripp419

Enthusiast
Messages
480
Reaction score
123
Points
125
Sin$
7
if u have a falcon make sure u put a 330 ohm resistor on the bridge wire and sometimes, actually 99% of the time u cant solder db1 u need to solder it from the bottom of the board most tuts dont ever say that but yah..i can guarentee you soldering of the jtag is bad or your diodes are fubar!!!
 
Top Bottom
Login
Register