What's new

Solved 4gb nand Reader

  • Thread starter XeGooch
  • Start date
  • Views 1,723
XeGooch

XeGooch

RGH/Jtag Seller!
Messages
481
Reaction score
103
Points
95
Sin$
0
Hello Se7ensins, I have making rgh's for about an month now and i have never read an 4GB nand yet.. so today i bought Element's 4GB Nand reader card. For those who don't no what it looks like it looks like this :wink: So all i know is i need to solder wires to the SD Card and then to the wires to the nand part where u1d1 output header is on the board. But idk what wire goes where on the nand points. Its not like J-R Progrmmer. If someone could help me with a good diagram it would be nice Thanks :smile:

3faaec1c48034698306034e5e7edb6dd.png
 
J

JoinTheResistance

Dead to the world, alive for the journey...
Messages
4,669
Reaction score
1,100
Points
1,045
Sin$
7
Use this to set it up http://i.imgur.com/VeWvR.jpg
Not 100% sure yours is the same, but it should work.
Btw, if you draw me a diagram of yours I'll be able to make sure it's going to work with the diagram I gave you.
 
XeGooch

XeGooch

RGH/Jtag Seller!
Messages
481
Reaction score
103
Points
95
Sin$
0
You don't need to add the resistor, it should already on the board you bought. Just make sure that you are soldering to the pads with the holes in them, not the ones that go into the card reader.
resistor.png
Okay how would ik what sodler point goes to what on the board on that chip tho?
 
Top Bottom
Login
Register