What's new

Solved ⚠️⚠️RGH POWERS ON BUT WONT BOOT⚠️⚠️

Z

Zazii

Enthusiast
Messages
83
Reaction score
12
So I've been in the modding community for about 4-5 years, and I've never had this issue, I don't wanna talk about my whole life story so let me get into the issue. My console was working fine until I unplugged everything for about 4-5 days and then when trying to boot, it will power on, but will not boot, I've tried removing HDD and booting, nothing, I've tried changing both the power brick, cord, and HDMI cable, no effect, I've tried booting to Xell, nothing, my light on both bricks are green when turned on, and orange when off, I've switched outlets, and tested my retail console to see if it would boot, It Did. I'll leave the console type, you might want it for whatever reason,

Console type:
Xbox 360 S Corona RGH 2.0


If you have any ideas/advice please let me know
 
A

Algorithmic

Love Hosting For The Community!
Messages
1,984
Reaction score
759
Sounds like it's bricked to me if im being honest.
 
N

Newsk

Contributor
Messages
2,505
Reaction score
330
Well first look inside the slim through the sode panel at the chip and when powering on look for a debug light . Depending on the chip /timings it should flash or pulse (green led or blue led usually ). Is it doing anything ?
 
Z

Zazii

Enthusiast
Messages
83
Reaction score
12
Well first look inside the slim through the sode panel at the chip and when powering on look for a debug light . Depending on the chip /timings it should flash or pulse (green led or blue led usually ). Is it doing anything ?
Where do I find the chip? 
Well first look inside the slim through the sode panel at the chip and when powering on look for a debug light . Depending on the chip /timings it should flash or pulse (green led or blue led usually ). Is it doing anything ?
when I boot, I see a red light, then a green light will flash, the. Back to red, the flash green again
 
N

Newsk

Contributor
Messages
2,505
Reaction score
330
that means its glitching just not booting. how long have you let it attempt to boot like this?

your gonna probably have to either contact the installer that did the work or send it in to someone to have them take it apart and have a look-see.
 
2

2liftheavy

Getting There
Messages
1,314
Reaction score
134
If you can't boot xell, then your nand is messed up. An RGH will not mess up the nand itself
This is done by the user in someway
You will need to manually reflash your nand, which requires soldering. No way around it
 
I

iIVIoNoXiDe

JTAG/RGH Seller
Messages
52
Reaction score
10
Could maybe a trapped wire (cpu rst) or hardware failure. I'd take it apart 1st and have it out of the metal cage then try turning it on
 
T

Turtle wave

Truth ent. Rgh support
Messages
1,008
Reaction score
232
The console can't do it on it's own lol. Because glitched things never glitch out. Guess to be fair adding ninja.xex is something the user does.

Newsk is right its not glitching properly and you will most likely have to send it in. If you have a jrprogramer or equivalent installed you can try to reflash the nand like lifting heavy recommended.

4-5 years in i kind of hope you have one at this point. Best of luck to ya. If you're going to send it in for repair remember can buy another for $80
 
I

iIVIoNoXiDe

JTAG/RGH Seller
Messages
52
Reaction score
10
The console can't do it on it's own lol. Because glitched things never glitch out. Guess to be fair adding ninja.xex is something the user does.

Newsk is right its not glitching properly and you will most likely have to send it in. If you have a jrprogramer or equivalent installed you can try to reflash the nand like lifting heavy recommended.

4-5 years in i kind of hope you have one at this point. Best of luck to ya. If you're going to send it in for repair remember can buy another for $80
Ive had it done before. The pressure on the wire has finally given in after a long time and it needed to be re-routed so id always check that 1st
 
Top Bottom