R
ronsonol
Enthusiast
Hello all, looking for input as I can't figure this one out.
I have a DG-16D2S in a jasper that I've replace the drive belt and it still won't open. If I manually open it, it closes just fine the motor sounds good.
But it will not open. This is with no dvd in it and even without the lid on it.
What I notice is while attempting to open the motor only runs for a split second, just enough to start lowering the elevation guide arm, then immediately stops.
I don't believe it's a motor issue, I disconnected the leads and connected to another drives motor and it behaves the same.
This known good motor, would normally spin fine during both opening and closing connected to its original mainboard.
Any ideas? Many thanks for the help.
I have a DG-16D2S in a jasper that I've replace the drive belt and it still won't open. If I manually open it, it closes just fine the motor sounds good.
But it will not open. This is with no dvd in it and even without the lid on it.
What I notice is while attempting to open the motor only runs for a split second, just enough to start lowering the elevation guide arm, then immediately stops.
I don't believe it's a motor issue, I disconnected the leads and connected to another drives motor and it behaves the same.
This known good motor, would normally spin fine during both opening and closing connected to its original mainboard.
Any ideas? Many thanks for the help.
Last edited: