Bricked Drive? Benq now errors E65 and PC cant see it

[lellis2k]

Hi Guys, freaking out here so help would be great.

I've flashed my xbox a few times but this time had major problems.

Using xbox to power drive I half opened the tray and loaded jungle flasher,
Pressed benq unlock and it errored out and froze.
Now drive wont open or close, if I plug it in to tv I get lower right red light and error code E65 on TV (bad firmware).

If I boot with the drive plugged in to my VIA VT6421 sata card, the card gives the error "This device cannot start. (Code 10)" but is fine if the drive isn't plugged into it.

So basically I can't use the xbox as I get E65 and I can't re-flash it because the sata card doesn't work if the drive is plugged in.

Have I bricked it?
Is there anything I can do?
If I get a new drive from ebay what should I get and what to do differently next time?

Thanks,

Leigh

[EclipseModz]

It is possible that all that happened was the drive locked in Vendor Mode. This can easily be fixed by booting into DosFlash.

How to flash a 360 Benq drive using DosFlash 1.8

If it still does not work in DosFlash. Then yes the drive is bricked. Hopefully you have your original.bin to replace the drive.

[lellis2k]

I've just tried dosflash and it found the drive, read the firmware, made the hacked firmware and flashed it successfully...

but windows still won't see the drive and I still get error E65 on the tv.