usb wont flash

[convict]

ok all i gotten my card today also my usb flash i put the files on my usb drive to flash went into bios change boot to my usb now it wont boot using my usb also i get a black screen with a _ n the upper left hand corner just flashing

heres my card i got http://www.newegg.com/Product/Produc...82E16815124022

im running the sata cable from my xbox dvd to my card there r 2 slots for the cable to go in i have it in 1 also does the little green lights suppose to light up on the card and do i have to run a ide cable

[Venomous Fire]

make sure you have boot files on the usb

[convict]

yes i do i checked like 3 times to be sure

[Venomous Fire]

make sure you made it with a bootmaker and didnt just copy/paste the files over

[convict]

i use iprep 101to flash onto my usb driver

ok all some reason im having a problem trying to flash with a usb drive but it wont now im trying a new floppy i know its not recomend but i have no other choice anyways i have the floppy in
it brings me to this

for the following steps you need to
press yes to resend the mtk vendor intro command
turn on the drive wait for status to change to d1
turn off drive for 2 seconds
turn on the drivereading should start
mtk vendoe intro failed on port 0xd000 if u choose to resend the command
you should turn the drive off and on after u pressed yes
do u want to resend the command until the drive responds y/n i hit yes
status 0x7f it sits there just blinking its should change to d1 its not


ok now i have the sata wire coming from dvdbenq xbox going into the #1 slot on the sata card i guess u dont hook up a ide cable from mother board to sata card is this right??????/

[Venomous Fire]

For the drive, dont worry on what it hangs on....

And no, you dont need any IDE cable

[convict]

what do u mean dont worry what it hangs on

why does it just stays there flashing

[Venomous Fire]

What I mean by dont worry what it hangs on is exactly that..........

actually follow a tut instead of winging it....

[convict]

i read tuts watch videos twice or 3 times lol i read alot of stuff umm alot of peep sucedd with flashing not me my pc wont even boot into usb

[convict]

ok all i found the problem y it would boot my usb drive i try to boot from a 4 gig usb port no good so i read n forums and seen were someone had the same prob they bought a 1 gig and it werk same here i can boot from usb port but now when ni try to flash this is what it does now

for the following steps you need to
press yes to resend the mtk vendor intro command
turn on the drive wait for status to change to d1
turn off drive for 2 seconds
turn on the drivereading should start
mtk vendoe intro failed on port 0xd000 if u choose to resend the command
you should turn the drive off and on after u pressed yes
do u want to resend the command until the drive responds y/n i hit yes
status it flikers between 0x51just the 5 will fliker with the d