What's new

Solved rgh2.0 reading nand help

  • Thread starter SE7ENSINS OG
  • Start date
  • Views 898
SE7ENSINS OG

SE7ENSINS OG

☆HOSTER☆
Messages
534
Reaction score
224
Points
115
Sin$
0
`hello guys im having trouble reading my nand the past 2 weeks i went true 2 falcons both are DEAD
im now trying a jasper when i install the nand x wires to get a read of my nand
i get an error can not continue
 
SE7ENSINS OG

SE7ENSINS OG

☆HOSTER☆
Messages
534
Reaction score
224
Points
115
Sin$
0
NandX.jpg

now i have all the wire installed like in pic above but when i just put MY XBOX power lead in and the JRPV2
i get no light buy when i solder the red wire next to where the red is saposed to go i get lights can someone help me
 
Big_Ddog

Big_Ddog

Getting There
Messages
1,752
Reaction score
443
Points
220
Sin$
7
EVERY flash config 0x0000000 is due to poor soldering.

Use some flux touch up your solder points and try again.
 
SE7ENSINS OG

SE7ENSINS OG

☆HOSTER☆
Messages
534
Reaction score
224
Points
115
Sin$
0
yeah ok but im trying to say see where the red wire goes i solder to that point i put my power lead in but dont turn xbox on and i have the jrp pluged into the xbox i get no lights on jrp but when i solder red wire next to where its saposed to go i get light i hope you understand lol
 
Big_Ddog

Big_Ddog

Getting There
Messages
1,752
Reaction score
443
Points
220
Sin$
7
post pics of your soldering, For all I know you burned the point so now you can't connect. and if that is the case. go to the underside of the board for that point.
 
SE7ENSINS OG

SE7ENSINS OG

☆HOSTER☆
Messages
534
Reaction score
224
Points
115
Sin$
0
im getting this error now
Checking Console..
Version: 10
Flash Config: 0x00310030
IoTimedOut

IoTimedOut:No more bytes!
00310030
 
Top Bottom
Login
Register