This tut will show you how to use the stock light on the rol as a debug light for the rgh hack. you will need one 1n4148 switching diode ( same as used on jtag hack ) and some wire. please look at picks for the proper install of the diode. Ok you need to download and program the custom ground debug light .jed to you console. Then put the diode on the debug pad or pin of your glitch chip. Run a wire from the diode up to the rol and solder it to the green negitive pad. please note the xbox 360 uses a common positive (not negitive) for its lights this is why you must use the custom negitive .jed because the normal .jed uses pos on the debug pad and the custom .jed has been switched to negitive. you can down load the fat model custom ground debug .jeds here (i have not tested the slim yet will update the link after its done) http://glumbouploads.com/dzaqm1msh6l0 update--- the slim uses common negitive for its lights so dont do any of this to a slim new update-- you can use the normal .jed (not the custom one ) for your slim. just put the diode on the debug pad as seen in the pics and run a wire up to the positive side of one of the stock lights and that it your done.
